Thread Ring Gauges Calibration

Theses standards specify the tolerances and limits for simple forms of thread gauges, such as:

Parallel thread plug gauges

Parallel thread ring gauges

Care and use

1. Always select the thread gauge that best fits the application
2. Care should be taken while using thread gauges.  Should you drop a thread gauge, it should be re-calibrated/repaired before reusing it
3. Gauges should be protected from damage when not in use. Rhopoint recommend applying a specialist coating to the thread gauge when not in use, (full details on this process is available directly from Rhopoint, contact us for further information)
4. Do not use excessive force when applying the gauge to the component as this may result in either damage to the component or gauge
5. Never use a thread gauge that has not been calibrated, if in doubt consult an appropriate authority.

It is highly recommended that an appropriate authority such as a UKAS approved laboratory carries out a full calibration on thread gauges at least once a year. In between UKAS calibrations at a frequency based on usage, thread gauges should be calibrated in-house. A typical in-house calibration would include a written procedure and an associated calibration record sheet, which would contain as a minimum, the following listed information:

Thread gauges

(a) Serial number

(b) Location

(c) Procedure number

(d) Rate and compression correction

(e) Gauge tolerance

(f) Results

(g) Measurement uncertainty

(h) Sentence if appropriate

(i) Date and calibrators signature

(j) Traceability to National Standards

It is necessary that any person carrying out such calibration work should have received appropriate training and have shown the ability to be confident via a suitable training authority. Training records should be held and maintained.

Following are layouts for typical in-house calibrations for thread gauges:

Calibration to be carried out in accordance with in-house procedure number …………………..

Serial Number: Make:

Calibration Date: Sizes:

FEATURE EXAMINED                      SPEC.                      MEASURED RESULTS

GO:

Major diameter

Pitch diameter

Minor diameter

NOT GO:

Major diameter

Pitch diameter

Minor diameter

(Go and NOT go are measured at the front, middle and back of the thread)

The thread gauges were visually inspected for damage and the following faults were noted:

MEASUREMENT UNCERTAINTY +/- 0.003mm (1-100mm range)

Source: UKAS schedule of accreditation, Calibration and measurement capability (CMC)

Calibrators Signature: ………………………………….

A traceability statement in this section would be required for all items and their relevant certification utilised for the calibration of thread gauges.